Titan® CV47CSE0400 CV47-CS Dual Disc Wafer Check Valve, 4 in, Flanged, 900 lb, Carbon Steel Body, EPDM Seat, Stainless Steel Disc
CBPN: 251387
MPN:CV47CSE0400
DESCRIPTION
Titan® Check Valve, Dual Disc Wafer, Series: CV47-CS, 4 in Nominal, Flanged, 2220 psi WOG, 900 lb, 100 deg F, 4 in Inlet to Outlet Length, Carbon Steel Body, 316 Stainless Steel/EPDM/Inconel X-750 Trim, Epoxy Painted, 8.062 in OD
Check Valves are automatic shut-off valves that are commonly used for preventing backflow or drainage in a piping system. Often applied on the discharge side of pumps, check valves prevent the system from draining if the pump stops and protect against backflow, which could harm the pump or other equipment.
**Titan CV47CSE0400, a CV47-CS series valve with an EPDM disc, has been discontinued. Similar items with a Buna or metal seat are available. Please see below for similar items or contact us for additional options.
Titan® CV47CSE0400 CV47-CS Dual Disc Wafer Check Valve, 4 in, Flanged, 900 lb, Carbon Steel Body, EPDM Seat, Stainless Steel Disc
CBPN: 251387
MPN:CV47CSE0400
DESCRIPTION
Titan® Check Valve, Dual Disc Wafer, Series: CV47-CS, 4 in Nominal, Flanged, 2220 psi WOG, 900 lb, 100 deg F, 4 in Inlet to Outlet Length, Carbon Steel Body, 316 Stainless Steel/EPDM/Inconel X-750 Trim, Epoxy Painted, 8.062 in OD
Check Valves are automatic shut-off valves that are commonly used for preventing backflow or drainage in a piping system. Often applied on the discharge side of pumps, check valves prevent the system from draining if the pump stops and protect against backflow, which could harm the pump or other equipment.
**Titan CV47CSE0400, a CV47-CS series valve with an EPDM disc, has been discontinued. Similar items with a Buna or metal seat are available. Please see below for similar items or contact us for additional options.
Specifications
Item Features
- Cost efficient design: Low weight and short laying length produce savings in initial cost, space requirements, and installation when compared to full body, swing type check valves
- Minimal head loss: Contour of body provides a short and straight flow path that generates very little turbulence
- Additionally, the spring loaded disc is designed with very low cracking pressure which reduces the amount of energy required to open the valve
- Quick closure to reduce water hammer: Shut-off is achieved via the fully automatic, spring assisted discs that close near zero flow velocity
- The lightweight, split disc design creates a positive shutoff prior to flow reversal and helps to keep slamming and surges to a minimum
- Designed for long service life: The spring and discs are designed to allow the discs to lift linearly before pivoting to avoid the disc heal from scrubbing the sealing surface
- Also, discs are equipped with cast-in shock bumpers that help to reduce wear and tear on internal components
- Fugitive emission design: The retainer-less body design eliminates potential leak paths to The environment so there are no body emissions
- Resilient and metal seats: Board, lapped sealing surface (metal) meets or exceeds API 598 test requirements, resilient seats (Buna-N) ensure a bubble tight seal
Similar Items
CBPN:
251378
MPN:
CV47CSB0400
CBPN:
251396
MPN:
CV47CSM0400